View Single Post
  #2  
Old 02-16-2015, 04:45 AM
basskiller's Avatar
basskiller basskiller Is online now
Administrator

 
Join Date: Jan 2004
Location: Bodybuilding heaven
Posts: 129,552
Thanks: 3,591
Thanked 18,779 Times in 10,897 Posts
Rep Power: 4454
basskiller has a reputation beyond reputebasskiller has a reputation beyond reputebasskiller has a reputation beyond reputebasskiller has a reputation beyond reputebasskiller has a reputation beyond reputebasskiller has a reputation beyond reputebasskiller has a reputation beyond reputebasskiller has a reputation beyond reputebasskiller has a reputation beyond reputebasskiller has a reputation beyond reputebasskiller has a reputation beyond repute
In the center of the lid, drill one 3/4 inch hole for you tubing. You may have to ream out the hole just a bit to make the pvc tubing to slide through.

Also depending upon the location of your water flow exit , you may have to adjust the location of the hole in your lid.


Drill a bunch of 3/16" to 1/4" holes in the top lid. I wouldn't make them any bigger than 1/4 inch.
Attached Images
File Type: jpg 20141108_213845.jpg (81.9 KB, 6 views)
__________________

W C B B Sponsors
Southern Sarms
Egg Whites International

.. Any advice given on this board is just an opinion and not to be taken as medical advice. WCBB doesn't advocate or condone use of steroids. Check the laws in your country. WCBB just provides the platform in which to discuss such matters
Reply With Quote